Quick Start (Continued)
View
1. To view the appropriate program parameters, push the
parameter control knob to move the arrow to the left of
the program number.
2. Select the appropriate program number by rotating the
parameter control knob, then hold the knob in, releasing
after a new screen is displayed.
3. The new screen will outline the parameters currently
stored under that program number. Push the parameter
control knob again to return to the setup screen.
Load
1. To load a saved program, push the parameter control
knob to move the arrow to the left of the program
number. Please note that in addition to three available
programs, there is also the default program as outlined
in the “Initializing” section.
2. Rotate the knob to change the program number.
3. Push and hold the knob in, releasing after a new screen
is displayed. The new screen will read “Loaded Set N to
Current Parameters”.
4. Push the parameter control knob again to return to the
setup screen.
On-Line Help
In the Set Parameter Mode, an On-Line Help function is enabled.
On-Line Help provides a definition for all set parameters and
advanced functions.
1. To use On-Line Help, rotate the parameter control knob
so that the arrow is to the left of the parameter or feature
of interest (not the value of the parameter).
2. Push the parameter control knob in and hold until the
definition is displayed.
3. Push a second time to return to the Set Parameter Screen.
Mode Low voltage or high voltage range mode
Voltage The amplitude of the output pulse
P Length The time duration or length of the pulse