OPERATION:

• Connect the supplied 12

VDC power adapter to the

meter and to the mains line.

• Connect the ORP electrode

to the BNC socket on the

bottom of the meter.

• Always remove the elec-

trode protective cap before

taking any measurement. If

the electrode has been left

dry, soak the tip (bottom 2.5

cm) in rinse solution

(M10000B) for a few minutes to reactivate it.

• Turn the instrument on by pressing the ON/OFF key.

• Allow the reading to stabilize and the meter will start continuous monitoring.

• The meter is factory calibrated.

• A blinking alarm will indicate when the measured ORP value is lower or higher than the setpoint, depending on user selection.